Home › Drivetrain › K313F (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › 2018.05–2019.09
RM32H0E _52 Drivetrain _059618 K313F MULTIDRIVE / CVT _0300013 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K313F MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P175009  Brake ECU Malfunction  


DESCRIPTION

This DTC is stored if the ECM receives a malfunction signal from the brake actuator assembly (skid control ECU).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P175009 Brake ECU Malfunction When the vehicle is being driven at 20 km/h (12 mph) or more, the ECM receives a malfunction signal from the skid control ECU (brake actuator assembly) for 9 seconds or more (1-trip detection logic). Vehicle stability control system Comes on (Euro-OBD)
Does not come on (Except Euro-OBD)
DTC stored SAE Code:
P1750

CAUTION / NOTICE / HINT

HINT:

After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Drive the vehicle at 20 km/h (12 mph) or more for 9 seconds or more.



PROCEDURE

1.CHECK DTC OUTPUT (BRAKE CONTROL SYSTEM)
a.

Check for brake control system DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC/EPB > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B