Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER › from 2019.09
RM32H0E _58 Vehicle Interior _059647 DOOR LOCK _0292602 DOOR CONTROL RECEIVER A

DOOR LOCK  DOOR CONTROL RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning ECU and receiver removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Tire pressure warning ECU and receiver (Electrical key and tire pressure monitoring system receiver assembly)
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Registration(Click here)
for Initialization(Click here)
Door control receiver Register recognition code Wireless door lock operation w/o Entry and Start System
(Click here)

NOTICE:

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST


PROCEDURE

Hide 62480A 1.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

Hide 89741 2.REMOVE DOOR CONTROL RECEIVER (w/o Smart Key System)

NOTICE:
·

Do not drop, strike or otherwise subject the door control receiver to impact.

·

If the door control receiver is subjected to an impact, replace it with a new one.



a.
B450704

Remove the bolt.


b.

Disengage the guides.


c.

Disconnect the connector to remove the door control receiver.


Hide 89740A 3.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Smart Key System)

NOTICE:
·

Do not drop, strike or otherwise subject the smart door control receiver assembly to impact.

·

If the smart door control receiver assembly is subjected to an impact, replace it with a new one.



a.
B450705

Remove the bolt.


b.

Disengage the guides.


c.

Disconnect the connector to remove the smart door control receiver assembly.


Hide 897A0 4.REMOVE DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (w/ Tire Pressure Warning System)

NOTICE:
·

Do not drop, strike or otherwise subject the door control and tire pressure monitoring system receiver assembly to impact.

·

If the door control and tire pressure monitoring system receiver assembly is subjected to an impact, replace it with a new one.



a.
B450706

Remove the bolt.


b.

Disengage the guides.


c.

Disconnect the connector to remove the door control and tire pressure monitoring system receiver assembly.