Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT (for DENSO Made) › 2019.09–2020.08
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0299518 BLOWER UNIT(for DENSO Made) A

HEATING / AIR CONDITIONING  BLOWER UNIT(for DENSO Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blower unit removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
No. 1 blower damper servo sub-assembly Initialize servo motor (Air conditioning system) DTCs are stored (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal (for Audio and Visual System).

·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal (for Navigation System (for Radio and Display Type)).



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Make sure to perform initialization after replacing the No. 1 blower damper servo sub-assembly. If initialization is not performed, the air conditioner unit assembly will not perform properly as the air conditioning amplifier assembly will not be able to recognize the position of the No. 1 blower damper servo sub-assembly.


Hide 87130D 4.REMOVE BLOWER ASSEMBLY

a.
I113086

Disconnect the connector.


b.

Disengage the guides.


c.
I113087

Remove the 2 screws.


d.

Disengage the claws and guides to remove the blower assembly from the air conditioning radiator assembly.