Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR (for VALEO Made) › 2019.09–2020.08
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0295317 FRONT EVAPORATOR TEMPERATURE SENSOR(for VALEO Made) A

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR(for VALEO Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 cooler thermistor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Front Passenger Side Upper Air Mix)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Driver Side Upper Air Mix)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Driver Side Lower Air Mix)

·

No. 2 Air Conditioning Radiator Damper Servo Sub-assembly (Mode Switching)

·

No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Front Passenger Side Lower Air Mix)

·

Air conditioning amplifier assembly


Initialize servo motor (Air conditioning system) DTCs are stored (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal (for Audio and Visual System).

·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal (for Navigation System (for Radio and Display Type)).



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 87114L 3.REMOVE NO. 2 HEATER COVER (w/ PTC Heater)

Hide 87710G 4.REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)

Hide 88650N 5.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

Hide 87050C 7.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

Hide 87050C 8.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Manual Air Conditioning System)

Hide 87050D 9.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

Hide 87107A 12.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

Hide 88501 16.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

Hide 88625 17.REMOVE NO. 1 COOLER THERMISTOR

a.
I112417

Remove the No. 1 cooler thermistor.