Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
1.REMOVE FRONT WHEEL
2.REMOVE FRONT BUMPER ASSEMBLY
75602A
3.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY
75860A
4.REMOVE ROCKER PANEL MOULDING LH
53876A
5.REMOVE FRONT FENDER LINER LH (for TMMT Made)
for LHD:
Remove the 2 screws, 7 clips and front fender liner LH.
53875A
6.REMOVE FRONT FENDER LINER RH (for TMMT Made)
for RHD:
Remove the 2 screws, 6 clips and front fender liner RH.
53876A
7.REMOVE FRONT FENDER LINER LH (for TMC Made)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL
53117C
8.REMOVE NO. 1 RADIATOR GRILLE RETAINER
16561C
9.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
53579
10.REMOVE HOOD LOCK NUT CAP
53510
11.REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
53510
12.REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
| *a | Hood Lock Bolt |
Remove the 2 bolts and hood lock bolt.
Disengage the guide to remove the hood lock assembly from the hood lock control cable assembly.
53601
13.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
53601
14.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Disengage the guide.
Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.
53630
15.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Disconnect the hood lock control cable assembly from the clamps.
| *a | Grommet | - | - |
Disengage the grommet.
Pull the hood lock control cable assembly from the engine compartment to remove it.
53630
16.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Disconnect the hood lock control cable assembly from the clamps.
| *a | Grommet | - | - |
Disengage the grommet.
Pull the hood lock control cable assembly from the engine compartment to remove it.