Home › Engine / Hybrid System › 8NR-FTS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for AWD) › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _059909 8NR-FTS FUEL _0293906 FUEL SENDER GAUGE ASSEMBLY(for AWD) A

8NR-FTS FUEL  FUEL SENDER GAUGE ASSEMBLY(for AWD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)


CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A393066

Disengage the 2 clamps to disconnect the wire harness.

NOTICE:

Do not damage the wire harness.



b.
A393067

Remove the harness protector from the wire harness.

NOTICE:

Do not damage the wire harness.



c.
A393068

Disconnect the fuel sender gauge assembly connector.


d.
A393069

Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



Hide 58325E 3.REMOVE REAR FLOOR SERVICE HOLE COVER RH

a.
A395470

Using a clip remover with its tip wrapped with protective tape, remove the rear floor service hole cover and butyl tape.


b.

Disconnect the fuel return vent tube sub-assembly connector.


Hide 77144 4.REMOVE FUEL PUMP GAUGE RETAINER

HINT:

Perform the same procedure as for the fuel suction tube with pump and gauge assembly.

Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL PUMP (for AWD)>REMOVAL


Hide 77010 5.REMOVE FUEL TANK VENT TUBE ASSEMBLY

a.
A393070

Disconnect the fuel return vent tube sub-assembly and remove the fuel tank vent tube assembly from the fuel tank assembly.

Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



b.

Remove the fuel suction tube set gasket from the fuel tank assembly.


Hide 83320B 6.REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY

a.
A399316

Disengage the 2 clamps to disconnect the wire harness.

NOTICE:

Do not damage the wire harness.



b.

Disconnect the No. 2 fuel sender gauge assembly connector.


c.
A393072

Disengage the claw to remove the No. 2 fuel sender gauge assembly from the fuel tank vent tube assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.