45047
1.INSTALL TIE ROD END SUB-ASSEMBLY LH
| *a | Matchmark |
Install the lock nut and tie rod end sub-assembly LH to the steering gear assembly until the matchmarks are aligned.
After adjusting the toe-in, tighten the lock nut.
45046
2.INSTALL TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
3.INSTALL STEERING LINK ASSEMBLY
|
Install in this Direction |
Insert the steering link assembly as shown in the illustration.
Align the protrusion of the steering link assembly with the hole of the No. 1 steering column hole cover sub-assembly, and install the No. 1 steering column hole cover sub-assembly to the steering link assembly.
Check that the No. 1 steering column hole cover sub-assembly is securely installed.
Install the steering link assembly to the front suspension crossmember sub-assembly with the 2 bolts and 2 new nuts.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Make sure to tighten the bolts starting from the left side of the vehicle.
for AWD:
Install the wiring harness clamp bracket to the front suspension crossmember sub-assembly with the bolt.
Engage the clamp and Connect the connector.
for 2WD:
Install the wiring harness clamp bracket to the front suspension crossmember sub-assembly with the bolt.
Connect the connector.
45047
4.CONNECT TIE ROD END SUB-ASSEMBLY LH
Connect the tie rod end sub-assembly LH to the steering knuckle LH with the nut.
Do not damage the ball joint dust cover.
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
Install a new cotter pin.
45046
5.CONNECT TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
43215
6.INSTALL STEERING KNUCKLE SEAL (w/ Seal)
Use the same procedure for both sides.
|
Install in this Direction |
Engage the claw to install the steering knuckle seal as shown in the illustration.
Make sure that the steering knuckle seal is securely installed.
45025D
7.CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Engage the clip (B) to the vehicle body.
Engage the clip (A) to install the No. 1 steering column hole cover sub-assembly to the vehicle body.
Be careful not to damage the lip of the No. 1 steering column hole cover sub-assembly.
45260
8.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
45259A
9.INSTALL COLUMN HOLE COVER SILENCER SHEET
10.INSTALL FRONT WHEELS
11. STABILIZE SUSPENSION
12.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT