The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear engine oil seal removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION
30400
1.REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
When Using the Engine Support Bridge:
When Not Using the Engine Support Bridge:
32101B
2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat, level surface.
Using height adjustment attachments and plate lift attachments, place the engine assembly horizontally.
To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
Using an engine sling device and engine lift, secure the engine assembly before servicing.
Using SST, hold the crankshaft pulley.
Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and front drive plate spacer from the crankshaft.
11401L
3.REMOVE REAR ENGINE OIL SEAL
| *a | Protective Tape |
| *b | Cut Position |
Using a knife, cut off the rear engine oil seal lip.
Using a screwdriver, pry out the rear engine oil seal.
After removal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.
Tape the screwdriver tip before use.