The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head gasket removal/installation are shown below.
*1: When performing learning using the GTS
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION
11103
1.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY
13801
2.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
13750
3.REMOVE VALVE LASH ADJUSTER ASSEMBLY
13716
4.REMOVE VALVE STEM CAP
5.REMOVE CYLINDER HEAD SUB-ASSEMBLY
11115
6.REMOVE CYLINDER HEAD GASKET
Remove the cylinder head gasket from the cylinder block sub-assembly.
11101A
7.INSPECT CYLINDER HEAD SET BOLT