Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2019.09
RM32H0E _53 Suspension _059606 TIRE PRESSURE MONITORING _0292310 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

The IG circuit is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C422425E01
4.542,1.719 5.813,1.906 1.271,0.188 10 false M23 2.115,0.719 3.385,0.906 1.271,0.188 10 false ECU-IG1 NO. 4 4.542,1.896 5.938,2.292 1.396,0.396 10 false Tire Pressure Warning ECU and Receiver 4.729,1.146 5.167,1.396 0.438,0.25 10 false GND 4.729,0.573 5.167,0.823 0.438,0.25 10 false IG 4.448,0.469 4.885,0.719 0.438,0.25 10 false 1 4.417,0.99 4.854,1.24 0.438,0.25 10 false 12

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER POWER SOURCE)
a.
C368906C02
0.25,0.833 0.75,1.083 0.5,0.25 0.667,1.5 1.208,1.26 true 2.583,1.75 2.229,1.479 true 2.583,1.771 3.042,1.969 0.458,0.198 10 false GND 0.469,1.531 0.927,1.729 0.458,0.198 10 false IG 0.167,0.083 0.625,0.281 0.458,0.198 10 false *a 0.365,0.865 0.823,1.063 0.458,0.198 10 false M23
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


Disconnect the M23 tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
M23-1 (IG) - Body ground Ignition switch ON 10 to 16 V
Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M23-12 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR