Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor) › from 2019.09
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0298708 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor)  B1497  Communication Malfunction (Bus Ic)  


DESCRIPTION

The air conditioning harness assembly connects the air conditioning amplifier assembly and the servo motors. The air conditioning amplifier assembly supplies power and sends operation instructions to each servo motor through the air conditioning harness assembly. Each servo motor sends damper position information to the air conditioning amplifier assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1497 Communication Malfunction (Bus Ic) Any of the following conditions is met:
·

Error in communication line

·

Open in communication line


·

Air conditioning harness assembly

·

No. 1 air conditioning radiator damper servo sub-assembly

·

Air conditioning amplifier assembly


Memorized
(10 seconds or more)*

*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Ignition switch ON ○ ○
Malfunction Status Error in communication line ○ -
Open in communication line - ○
Detection Time 10 seconds or more 10 seconds or more
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


WIRING DIAGRAM

E357691E30
3.958,6.542 5.521,7.021 1.563,0.479 10 false Air Conditioning Harness Assembly 0.104,7.667 3.948,8.156 3.844,0.49 10 false No. 1 Air Conditioning Radiator Damper Servo Sub-assembly 0.854,9.448 3.063,9.875 2.208,0.427 10 false : LIN Communication Line 5.51,4.646 7.125,5.146 1.615,0.5 10 false Air Conditioning Amplifier Assembly 5.51,4.469 5.823,4.667 0.313,0.198 10 false m5 5.646,3.635 6.198,3.885 0.552,0.25 10 false BUS 5.646,3.24 6.219,3.448 0.573,0.208 10 false BUSG 5.646,4.031 6.167,4.313 0.521,0.281 10 false BUSB 5.406,4.031 5.719,4.229 0.313,0.198 10 false 4 5.406,3.594 5.719,3.792 0.313,0.198 10 false 3 5.406,3.24 5.719,3.438 0.313,0.198 10 false 2 0.625,2.354 2.094,2.646 1.469,0.292 10 false Driver Side Air Mix*1 0.302,2.688 2.406,3.146 2.104,0.458 10 false Front Passenger Side Air Mix*2 0.75,4.438 1.906,4.719 1.156,0.281 10 false Mode Switching 0.25,6.542 2.354,7 2.104,0.458 10 false Front Passenger Side Air Mix*1 0.615,6.875 2.417,7.375 1.802,0.5 10 false Driver Side Air Mix*2 3.771,3.24 4.083,3.438 0.313,0.198 10 false 6 3.771,3.583 4.083,3.781 0.313,0.198 10 false 7 3.771,4.031 4.083,4.229 0.313,0.198 10 false 8 5.24,8.167 6.708,8.458 1.469,0.292 10 false *1: for LHD 5.24,8.5 6.708,8.792 1.469,0.292 10 false *2: for RHD 0.104,7.469 1.573,7.76 1.469,0.292 10 false m2

PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (AIR MIX SERVO TARG PULSE(D))
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Air Mix Servo Targ Pulse(D) No. 1 air conditioning radiator damper servo sub-assembly (driver side air mix) pulse Min.: 128
Max.: 383
for LHD:

Operates between 165 to 257 pulses


for RHD:

Operates between 255 to 347 pulses


Body Electrical > Air Conditioner > Active Test
Tester Display
Air Mix Servo Targ Pulse(D)
50004 121 24
OK:

No. 1 air conditioning radiator damper servo motor operates smoothly.



Result:
Result Proceed to
No. 1 air conditioning radiator damper servo motors are malfunctioning A
No. 1 air conditioning radiator damper servo motors is normal B



A

2.INSPECT AIR CONDITIONING HARNESS ASSEMBLY (AIR CONDITIONING AMPLIFIER ASSEMBLY - NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY)

B

4.CHECK FOR DTC
2.INSPECT AIR CONDITIONING HARNESS ASSEMBLY (AIR CONDITIONING AMPLIFIER ASSEMBLY - NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY)
NOTICE:

When inspecting the air conditioning amplifier assembly, do not bring the tester probes too close to each other as a short circuit may occur.


a.

Disconnect the m5 air conditioning amplifier assembly connector.


b.

Disconnect the m2 No. 1 air conditioning radiator damper servo sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
m5-2 (BUSG) - Body ground Always Below 1 Ω
m5-3 (BUS) - m2-7 Always Below 1 Ω
m5-4 (BUSB) - m2-8 Always Below 1 Ω
m5-3 (BUS) or m2-7 - Body ground Always 10 kΩ or higher
m5-4 (BUSB) or m2-8 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

3.INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY
NOTICE:

When inspecting the air conditioning amplifier assembly, do not bring the tester probes too close to each other as a short circuit may occur.


a.

Turn the ignition switch ON.


b.
E334625C48
2.865,0.417 3.198,0.625 0.333,0.208 2.99,1.26 2.271,2.073 true 3.094,1.271 2.688,2.24 true 0.198,0.135 0.51,0.333 0.313,0.198 10 false *a 2.958,0.438 3.271,0.635 0.313,0.198 10 false m5 2.094,2.094 2.552,2.292 0.458,0.198 10 false BUS 2.469,2.271 2.927,2.51 0.458,0.24 10 false BUSG 0.417,3.927 0.875,4.125 0.458,0.198 10 false GND
*a Component with harness connected
(Air Conditioning Amplifier Assembly)


Connect an oscilloscope to terminals m5-2 (BUS G) and m5-3 (BUS) of the air conditioning amplifier assembly and check the waveform.

OK:

Waveform is similar to that shown in the illustration.


HINT:

The waveform varies with the blower speed.


Item Content
Tool Setting 2 V/DIV., 2 ms./DIV.
Vehicle Condition Ignition switch ON.


Result:
Proceed to
OK
NG



OK

REPLACE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

4.CHECK FOR DTC


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY