The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the back-up light switch assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
28800
3.REMOVE BATTERY
53141F
4.REMOVE RADIATOR COVER
17751
5.REMOVE NO. 1 AIR CLEANER INLET
17705
6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17701
7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
8.REMOVE ECM
74404A
9.REMOVE BATTERY CLAMP SUB-ASSEMBLY
84210
10.REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
Disconnect the back-up light switch assembly connector.
| *a | 27 mm Deep Socket Wrench |
Using a 27 mm deep socket wrench, remove the back-up light switch assembly and gasket from the manual transaxle assembly.