Home › Drivetrain › CLUTCH › CLUTCH PEDAL (for LHD) › 2019.09–2020.08
RM32H0E _52 Drivetrain _059611 CLUTCH _0292338 CLUTCH PEDAL(for LHD) A

CLUTCH  CLUTCH PEDAL(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the clutch pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
B448782

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here


PROCEDURE

Hide 31410 2.DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY

a.
C366486

Remove the clip from the clevis pin.


b.

Remove the clevis pin and disconnect the clutch master cylinder assembly from the clutch pedal sub-assembly.


Hide 3.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY

a.
C366476

Disconnect the 2 connectors.


b.

Disengage the clamp from the clutch pedal support assembly.


c.
C366488

Remove the bolt and No. 4 instrument panel bracket from the clutch pedal support assembly.


d.

Remove the 2 nuts and clutch pedal support assembly from the clutch master cylinder assembly.


Hide 88280A 4.REMOVE CLUTCH SWITCH ASSEMBLY

Hide 89280 5.REMOVE CLUTCH PEDAL STROKE SENSOR ASSEMBLY

Hide 31301A 6.REMOVE CLUTCH PEDAL SPRING

a.
C366490

Move the pedal to the full stroke position and remove the clutch pedal spring.


Hide 31301 7.REMOVE CLUTCH PEDAL SUB-ASSEMBLY

a.
C366492

Remove the bolt, nut, clutch pedal sub-assembly and clutch pedal bracket sub-assembly from the clutch pedal support sub-assembly.


Hide 31353 8.REMOVE CLUTCH PEDAL SPRING HOLDER

a.
C366494

Remove the clutch pedal spring holder from the clutch pedal bracket sub-assembly.


Hide 9.REMOVE CLUTCH PEDAL TURNOVER BUSH

a.
C366496

Remove the clutch pedal turnover bush from the clutch pedal sub-assembly.


Hide 31324A 10.REMOVE CLUTCH PEDAL SHAFT COLLAR

a.
C366498

Remove the 2 clutch pedal bushes and clutch pedal shaft collar from the clutch pedal sub-assembly.


Hide 31453B 11.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH

a.
C366500

Using SST and a hammer, tap out the clutch master cylinder push rod clevis bush from the clutch pedal sub-assembly.

SST
09201-01055  09950-70010  (09951-07100)


Hide 31321 12.REMOVE CLUTCH PEDAL PAD

a.
C366502

Remove the clutch pedal pad from the clutch pedal sub-assembly.