Make sure to release vacuum from the brake booster assembly before removing the master cylinder sub-assembly from the brake booster assembly.
47201
1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
31410
2.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY (for Manual Transaxle)
47101A
3.REMOVE BRAKE PEDAL RETURN SPRING
4.LOOSEN CLEVIS LOCK NUT
| *1 | Clevis Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
Loosen the clevis lock nut of the brake master cylinder push rod clevis.
47264A
5.REMOVE PUSH ROD PIN
51441
6.REMOVE NO. 1 ENGINE UNDER COVER (for 8NR-FTS)
55225
7.REMOVE DASH PANEL HEAT INSULATOR (for 8NR-FTS)
Remove the nut.
Remove the 2 nuts and dash panel heat insulator.
44750
8.SEPARATE VACUUM HOSE ASSEMBLY
Remove the 2 nuts and separate the vacuum hose assembly.
9.SEPARATE BRAKE TUBE
Using a union nut wrench, disconnect the front No. 3 brake tube from the front brake flexible hose.
Using a union nut wrench, disconnect the front No. 1 brake tube, front No. 2 brake tube and front No. 3 brake tube from the brake actuator assembly.
Disengage the 11 clamps to remove the 2 No. 1 brake tube clamps from the front No. 1 brake tube, front No. 2 brake tube, front No. 3 brake tube and front No. 5 brake tube.
| *1 | Brake Tube |
| *2 | Clutch Tube |
for Manual Transaxle:
Disengage the clamp to separate the clutch tube from the 2 brake tube clamps.
Disengage the 6 clamps to separate the 2 No. 2 brake tube clamps from the front No. 1 brake tube, front No. 2 brake tube and front No. 3 brake tube.
Disengage the 2 clamps to remove the No. 2 brake tube clamps from the vehicle body.
Disengage the 3 clamps to remove the No. 1 brake tube clamp from the front No. 1 brake tube, front No. 2 brake tube and front No. 3 brake tube.
10.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE
Slide the clip and disconnect the check valve to connector tube hose from the brake booster assembly.
88707
11.SEPARATE SUCTION PIPE SUB-ASSEMBLY (for TMMT Made)
Remove the 2 nuts and separate the suction pipe sub-assembly from the engine mounting sub-assembly and vehicle body.
88707
12.INSTALL SUCTION PIPE SUB-ASSEMBLY (for TMC Made)
Disengage the 2 clamps to separate the suction pipe sub-assembly from the piping clamp.
44610
13.REMOVE BRAKE BOOSTER ASSEMBLY
w/ Vacuum Warning Switch:
Disconnect the vacuum warning switch connector from the vacuum warning switch assembly.
|
Protective Tape |
Apply protective tape around the vehicle body.
Remove the 4 nuts.
Remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.
Move aside the front No. 1 brake tube, front No. 2 brake tube and front No. 3 brake tube as shown in the illustration.
Do not apply excessive force to the brake tubes.
While pushing the suction pipe sub-assembly toward the bottom of the vehicle, remove the brake booster assembly.
Do not apply excessive force to the brake tubes or refrigerant lines.
Do not apply excessive force to the suction pipe sub-assembly.
44785
14.REMOVE BRAKE BOOSTER GASKET
Remove the brake booster gasket from the brake booster assembly.