This DTC is stored when there is an open or short circuit in the communication line between the front corner ultrasonic sensor LH and the front center ultrasonic sensor LH, or when there is a malfunction in the front center ultrasonic sensor LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE287 | Ultrasonic Sensor (Front Left Center) Missing Message | Front center ultrasonic sensor LH lost communication | ·
Front center ultrasonic sensor LH ·
Harness or connector ·
Clearance warning ECU assembly |
Perform TOYOTA parking assist-sensor system registration.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Clear the DTCs.
Recheck for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE187 | C1AE287 | C1AE387 | C1AE487 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Output | Not output | Not output | Not output |
| Symptom 3 | Output | Output | Not output | Not output |
| Symptom 4 | Output | Output | Output | Not output |
| Symptom 5 | Output | Output | Output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>C1AE187
C
D
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>C1AE387
E
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>C1AE487
Disconnect the B8 front center ultrasonic sensor LH connector.
Disconnect the B9 front center ultrasonic sensor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B8-4 (BI) - B9-1 (BO) | Always | Below 1 Ω |
| B8-5 (SI) - B9-2 (SO) | Always | Below 1 Ω |
| B8-6 (EI) - B9-3 (EO) | Always | Below 1 Ω |
| B8-4 (BI) or B9-1 (BO) - Body ground | Always | 10 kΩ or higher |
| B8-5 (SI) or B9-2 (SO) - Body ground | Always | 10 kΩ or higher |
| B8-6 (EI) or B9-3 (EO) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front center ultrasonic sensor LH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
Inspect the front center ultrasonic sensor LH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
Replace the front center ultrasonic sensor LH with a known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a new or known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AE287 is output | A |
| No DTCs are output | B |
A
B