In some cases, wireless door lock control functions are normal but the hazard warning light answer-back function does not operate. In such cases, hazard warning light signal outputs from the main body ECU (multiplex network body ECU) may be malfunctioning.
The wireless door lock control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the wireless door lock control system after confirming that the communication systems are functioning properly.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Customize Setting / Wireless Door Lock.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Hazard Answer Back | When the doors are locked by wireless operation, the hazard warning lights flash once.
When the doors are unlocked by wireless operation, the hazard warning lights flash twice. |
ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
| Result | Proceed to |
|---|---|
| Customize setting is ON | A |
| Customize setting is OFF | B |
A
B
Check the wireless door lock control function using the door control transmitter assembly.
| Result | Proceed to |
|---|---|
| Wireless door lock/unlock operates properly. | A |
| Wireless door lock/unlock does not operate properly. | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Door Lock Pos | Front door RH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FL Door Lock Pos | Front door LH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| RR-Door Lock Pos SW | Rear door RH and LH unlock detection switch signal | ON or OFF | ON: Rear door RH or LH unlocked
OFF: Rear door RH and LH locked |
*1 |
| RL-Door Lock Pos SW | Rear door RH and LH unlock detection switch signal | ON or OFF | ON: Rear door RH or LH unlocked
OFF: Rear door RH and LH locked |
*2 |
*1: When checking RR-Door Lock Pos SW, make sure to check it with the rear door LH locked.
*2: When checking RL-Door Lock Pos SW, make sure to check it with the rear door RH locked.
| Tester Display |
|---|
| FR Door Lock Pos |
| FL Door Lock Pos |
| RR-Door Lock Pos SW |
| RL-Door Lock Pos SW |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the hazard warning light blinks when the hazard warning signal switch is pressed.
Hazard warning light signal blinks when the hazard warning signal switch is pressed.
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG (w/ Headlight ECU) | C |
| NG (w/o Headlight ECU) | D |
A
B
C
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>Hazard Warning Switch Circuit
D
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/o Headlight ECU)>Hazard Warning Switch Circuit