Home › Engine / Hybrid System › 8NR-FTS (COOLING) › THERMOSTAT(for Cylinder Block) › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _060195 8NR-FTS COOLING _0295084 THERMOSTAT(for Cylinder Block) A

8NR-FTS COOLING  THERMOSTAT(for Cylinder Block)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the thermostat (for Cylinder Block) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision syatem
Parking support brake system*1
Initialize back door lock Power door lock control system (Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF thermal Degradation Estimate" is not estimated correctly for K313
(Click here)
for 313F
(Click here)
Front wheel alignment adjustment Perform the following procedures in the order shown:
1.

Clear zero point calibration data and store system information

2.

Perform yaw rate and acceleration sensor zero point calibration and store system information


·

VSC disabled or malfunctions

·

DTCs are stored

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)

PROCEDURE

Hide 11310 1.REMOVE TIMING CHAIN COVER ASSEMBLY

Hide 16321 2.REMOVE WATER INLET

a.
A350052

Remove the 3 bolts, water inlet and heater return gasket from the cylinder block sub-assembly.


Hide 16331A 3.REMOVE THERMOSTAT (for Cylinder Block)

a.
A350053

Remove the thermostat (for Cylinder Block) from the cylinder block sub-assembly.


b.

Remove the No. 1 water inlet housing gasket from the thermostat (for Cylinder Block).