The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pump assembly removal/ installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced
| Replacement Part or Procedure
|
Necessary Procedure
|
Effect/Inoperative when not Performed
|
Link
|
|
|
| Disconnect cable from negative battery terminal
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
( )
|
| Toyota parking assist-sensor system*1
|
| Parking support brake system*1
|
| Simple intelligent parking assist system*1
|
| Pre-collision syatem
|
| Memorize steering angle neutral point
|
Panoramic view monitor system
|
( )
|
| Initialize back door lock
|
Power door lock control system
|
( )
|
| Replacement of CVT fluid
|
ATF thermal degradation estimate reset
|
The value of the Data List item "ATF thermal Degradation Estimate" is not estimated correctly
|
for K313
( )
for K313F
( )
|
| Front wheel alignment adjustment
|
Perform the following procedures in the order shown:
1.
Clear zero point calibration data and store system information
2.
Perform yaw rate and acceleration sensor zero point calibration and store system information
|
·
VSC disabled or malfunctions
·
Slip indicator light illuminates
·
ABS warning light illuminates
|
( )
|