Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0297889 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P157800  Brake System  


DESCRIPTION

This DTC is stored when a malfunction is detected in the vehicle stability control system or electric parking brake system. Check the vehicle stability control system and electric parking brake system when DTC P157800 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
P157800 Brake System
w/o Full-speed range following function:
·

While the dynamic radar cruise control system is operating, a malfunction in the vehicle stability control system is detected by the ECM for 0.2 seconds or more.


w/ Full-speed range following function:
·

While the dynamic radar cruise control system is operating, a malfunction in the vehicle stability control system is detected by the ECM for 0.2 seconds or more.

·

While the dynamic radar cruise control system is operating, a malfunction in the electric parking brake system is detected by the ECM for 0.2 seconds or more.


·

Vehicle stability control system

·

Electric parking brake system

·

Skid control ECU (brake actuator assembly)

·

ECM



CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the ECM refer to Service Bulletin.

·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM AND ELECTRIC PARKING BRAKE SYSTEM)
a.

Check for DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC/EPB > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
Vehicle stability control system DTCs are output B
Electric parking brake system DTCs are output C



A

2.CHECK FOR DTCs (CRUISE CONTROL)

B

C

2.CHECK FOR DTCs (CRUISE CONTROL)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

1.

Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC P157800 is not output A
DTC P157800 is output B



A

B

3.REPLACE ECM
3.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTCs (CRUISE CONTROL)
4.CHECK FOR DTCs (CRUISE CONTROL)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

1.

Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC P157800 is not output A
DTC P157800 is output (for LHD) B
DTC P157800 is output (for RHD) C



A

END

B

C