The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
45100
3.REMOVE STEERING WHEEL ASSEMBLY
Disconnect the 2 connectors from the spiral cable with sensor sub-assembly.
w/ Steering Heater:
Disconnect the steering heater connector.
| *a | Matchmark |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and steering main shaft.
| *a | Turn |
| *b | Hold |
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
45186
4.REMOVE LOWER NO. 2 STEERING WHEEL COVER
84632
5.REMOVE CRUISE CONTROL MAIN SWITCH
84250A
6.REMOVE STEERING PAD SWITCH ASSEMBLY