The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the radiator grille removal/installation are shown below.
88211B
1.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Toyota Safety Sense)
2.REMOVE FRONT BUMPER ASSEMBLY (w/o Toyota Safety Sense)
53111
3.REMOVE RADIATOR GRILLE
w/o Panoramic View Monitor System:
Disengage the wire harness clamp.
w/ Panoramic View Monitor System:
Disengage the wire harness clamps.
Remove the 2 bolts.
Disengage the claws to remove the radiator grille.