Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door) › from 2020.08
RM32H0E _59 Vehicle Exterior _060314 WINDOW / GLASS _0298547 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 69284D 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 84810D 4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Hide 67498 5.REMOVE REAR DOOR REAR FRAME BRACKET

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67498 7.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP

Hide 68197 8.REMOVE REAR DOOR BELT SEAL

Hide 68199 9.REMOVE REAR DOOR BELT REAR SEAL

Hide 67842E 10.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 67674A 11.REMOVE REAR DOOR FRAME GARNISH

Hide 68152C 12.REMOVE REAR DOOR GLASS RUN

Hide 67408F 13.REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

Hide 68104 14.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 15.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 85720E 16.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B454701

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.