Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0291560 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).


a.
B586031C04
2.573,0.677 2.688,0.844 0.115,0.167 10 true 1 0.76,0.635 0.875,0.833 0.115,0.198 10 true 2 1.802,0.052 1.906,0.229 0.104,0.177 10 true 3
V100135

Bolt
V100136

Screw


Engage the guides.


b.

Install the millimeter wave radar sensor assembly with the 2 bolts and screw.

Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)

HINT:

Tighten the bolts in the order shown in the illustration.



Hide 88215 2.INSTALL NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET

a.
C365304

Engage the guide.


b.

Install the No. 1 millimeter wave radar sensor bracket with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 3.INSTALL FRONT BUMPER ASSEMBLY

Hide 4.ADJUST MILLIMETER WAVE RADAR SENSOR

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

HINT:

Millimeter wave radar sensor assembly Learning can be performed by using either Triangle Target or Flat Surface Target or Driving Adjustment.