Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0297889 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U032251  Software Incompatibility with Body Control Module Not Programmed  


DESCRIPTION

If the millimeter wave radar sensor assembly cannot confirm the vehicle information (steering wheel position) sent from the main body ECU (multiplex network body ECU), the millimeter wave radar sensor assembly stores DTC U032251.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U032251 Software Incompatibility with Body Control Module Not Programmed While the dynamic radar cruise control system is operating, the millimeter wave radar sensor assembly cannot confirm the vehicle information (steering wheel position) sent from the main body ECU (multiplex network body ECU) for approximately 6 seconds or more. Millimeter wave radar sensor assembly Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.

·

When the millimeter wave radar sensor assembly has been replaced with a new one, it is necessary to perform millimeter wave radar sensor assembly beam axis alignment and to clear the vehicle control history. Before performing the Driving Adjustment, make sure to read Before Starting Driving Adjustment.

HINT:

Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.

Triangle Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(TRIANGLE TARGET)

Flat Surface Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(FLAT SURFACE TARGET)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT




PROCEDURE

1.REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
HINT:

Replace the millimeter wave radar sensor assembly with a new one.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

Result:
Proceed to
NEXT



NEXT

END