Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.08
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295246 BATTERY CURRENT SENSOR A

8NR-FTS BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Engage the 2 claws and install the battery state sensor assembly to the battery current sensor holder.


b.

Engage the clamp and connect the engine wire to the battery state sensor assembly.


c.

Connect the battery state sensor assembly connector.


d.

Connect the battery state sensor assembly to the battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


e.

Connect the engine wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 3. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART