Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U041881  Invalid Data Received from Brake System Control Module Invalid Serial Data Received  


DESCRIPTION

The millimeter wave radar sensor assembly receives signals related to the brake control condition from the skid control ECU (brake actuator assembly) via the CAN communication line.

If the millimeter wave radar sensor assembly receives signals from the skid control ECU (brake actuator assembly) indicating a brake control system malfunction, the millimeter wave radar sensor assembly stores DTC U041881.

DTC No. Detection Item DTC Detection Condition Trouble Area
U041881 Invalid Data Received from Brake System Control Module Invalid Serial Data Received When the ignition switch is ON for 3 seconds or more, the millimeter wave radar sensor assembly receives a brake control system malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more.
·

Millimeter Wave Radar Sensor Assembly

·

Skid Control ECU (Brake Actuator Assembly)



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.

·

When the millimeter wave radar sensor assembly has been replaced with a new one, it is necessary to perform millimeter wave radar sensor assembly beam axis alignment and to clear the vehicle control history. Before performing the Driving Adjustment, make sure to read Before Starting Driving Adjustment.

HINT:

Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.

Triangle Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(TRIANGLE TARGET)

Flat Surface Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(FLAT SURFACE TARGET)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT




PROCEDURE

1.CHECK FOR DTCs
a.

Using the GTS, check for vehicle stability control system DTCs.

HINT:

If DTC U041881 is output by the pre-collision system, perform troubleshooting for the vehicle stability control system.


Chassis > ABS/VSC/TRAC/EPB > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

B