The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear door belt moulding removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
74272A
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
67498
5.REMOVE REAR DOOR REAR FRAME BRACKET
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68199
7.REMOVE REAR DOOR BELT REAR SEAL
68174A
8.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
68197
9.REMOVE REAR DOOR BELT SEAL
67872
10.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the rear door weatherstrip until the screw of the door window rear lower sub-assembly is visible.
67842E
11.REMOVE REAR DOOR SERVICE HOLE COVER
67408F
12.REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY
68104
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
67674A
14.REMOVE REAR DOOR FRAME GARNISH
68152C
15.REMOVE REAR DOOR GLASS RUN
68124B
16.REMOVE REAR DOOR QUARTER WINDOW GLASS
75740
17.REMOVE REAR DOOR BELT MOULDING ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear door belt moulding assembly.
|
Remove in this Direction |
Disengage the claws to remove the rear door belt moulding assembly as shown in the illustration.