The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the black out tape removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
74272A
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
67498
5.REMOVE REAR DOOR REAR FRAME BRACKET
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68199
7.REMOVE REAR DOOR BELT REAR SEAL
68174A
8.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
68197
9.REMOVE REAR DOOR BELT SEAL
67842E
10.REMOVE REAR DOOR SERVICE HOLE COVER
67872
11.REMOVE REAR DOOR WEATHERSTRIP
67408F
12.REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY
68104
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
67674A
14.REMOVE REAR DOOR FRAME GARNISH
68152C
15.REMOVE REAR DOOR GLASS RUN
68124B
16.REMOVE REAR DOOR QUARTER WINDOW GLASS
75978H
17.REMOVE REAR DOOR LOWER OUTSIDE STRIPE
When removing the rear door lower outside stripe, heat the vehicle body and rear door lower outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Lower Outside Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the rear door lower outside stripe and vehicle body.
Pull back on one of the ends of the rear door lower outside stripe to remove it.
When pulling on the rear door lower outside stripe, pull it parallel to the vehicle body.
75988E
18.REMOVE REAR DOOR OUTSIDE STRIPE
When removing the rear door outside stripe, heat the vehicle body and rear door outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Outside Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the rear door outside stripe and vehicle body.
Pull back on one of the ends of the rear door outside stripe to remove it.
When pulling on the rear door outside stripe, pull it parallel to the vehicle body.