When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1.REMOVE BATTERY
11212
2.REMOVE NO. 2 CYLINDER HEAD COVER
82121
3.DISCONNECT ENGINE WIRE
29300
4.REMOVE VACUUM PUMP ASSEMBLY
Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.
Remove the 3 bolts and vacuum pump assembly from the engine assembly.
| *1 | No. 2 O-ring |
| *2 | No. 3 O-ring |
Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.