REASSEMBLY
Removal / installation · Vehicles built from Jun 2009
| 1. INSTALL REAR DISC |
Aligning the matchmarks, install the rear disc.

- HINT:
- When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.
| 2. ADJUST PARKING BRAKE SHOE CLEARANCE |
- HINT:
- (Click here)
| 3. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Install the parking brake shoe adjusting hole plug.
| 4. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG |
Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder sub-assembly.
| 5. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP |
Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.
| 6. INSTALL PISTON SEAL |
Apply lithium soap base glycol grease to a new piston seal.
Install the piston seal to the rear disc brake cylinder assembly.
| 7. INSTALL CYLINDER BOOT |
Apply lithium soap base glycol grease to the piston and a new cylinder boot.

Install the cylinder boot to the piston as shown in the illustration.
| 8. INSTALL REAR DISC BRAKE PISTON |
Install the boot securely to the grooves of the cylinder.

Push in the piston by hand and install the boot onto the grooves of the piston.
- NOTICE:
- Install the boot securely to the grooves of the piston.
| 9. INSTALL REAR DISC BRAKE BUSHING DUST BOOT |
Apply lithium soap base glycol grease to the seal surfaces of 2 new rear disc brake bushing dust boots.

Apply lithium soap base glycol grease to the sliding part and the seal surface of the rear disc brake cylinder slide pins.
Install the 2 rear disc brake bushing dust boots to the rear disc brake cylinder slide pins.
| 10. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN |
Install the 2 pins (upper and lower) to the bottom side of the rear brake cylinder mounting.

Install the 2 rear disc brake bushing dust boots to the groove of the rear brake cylinder mounting.
| 11. INSTALL REAR DISC BRAKE CYLINDER MOUNTING |
Install the rear disc brake cylinder mounting with the 2 bolts.

- Torque:
- 47 N*m{ 479 kgf*cm , 35 ft.*lbf }
| 12. INSTALL REAR BRAKE PAD |
Install the 2 rear brake pads to the rear disc brake cylinder mounting.

