HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- Use the following procedures to troubleshoot the air conditioning system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
Inspect the battery voltage.
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN Communication System is functioning normally.
- Result:
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
CAN DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Check for DTCs and note any codes that are output.
- HINT:
- Refer to the DTC CHECK / CLEAR (Click here).
Delete the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to force output of the A/C system DTC by simulating the operation indicated by the DTC.
- Result:
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Refer to the PROBLEM SYMPTOMS TABLE (Click here).
- Result:
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
ACTUATOR CHECK (Click here for Automatic A/C)
DATA LIST / ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
ON-VEHICLE INSPECTION
INSPECTION
| NEXT |
|
 |
|
|
| 7.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|