2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Headlight Beam Level Control Actuator Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

DESCRIPTION

The headlight leveling ECU actuates the headlight leveling motor according to the vehicle conditions.

WIRING DIAGRAM

E116048E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING MOTOR - HEADLIGHT LEVELING ECU)

  1. Check the harness and connector between the headlight leveling ECU and headlight leveling motor LH.

    1. E116072E09
      Disconnect the A12 headlight leveling motor LH connector.

    2. Disconnect the A20 headlight leveling ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      A20-11 (LH+) - A12-3 (LHB1)
      Always
      Below 1 Ω
      A20-24 (LH-) - A12-1 (LHE)
      Always
      Below 1 Ω
      A20-18 (LHE) - A12-2 (LHM+)
      Always
      Below 1 Ω
      A20-11 (LH+) - Body ground
      Always
      10 kΩ or higher
      A20-24 (LH-) - Body ground
      Always
      10 kΩ or higher
      A20-18 (LHE) - Body ground
      Always
      10 kΩ or higher

  1. Check the harness and connector between the headlight leveling ECU and headlight leveling motor RH.

    1. E116072E10
      Disconnect the A33 headlight leveling motor RH connector.

    2. Disconnect the A20 headlight leveling ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      A20-10 (RH+) - A33-3 (RHB1)
      Always
      Below 1 Ω
      A20-23 (RH-) - A33-1 (RHE)
      Always
      Below 1 Ω
      A20-17 (RHE) - A33-2 (RHM+)
      Always
      Below 1 Ω
      A20-10 (RH+) - Body ground
      Always
      10 kΩ or higher
      A20-23 (RH-) - Body ground
      Always
      10 kΩ or higher
      A20-17 (RHE) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Height Control Sensor Circuit (Oct 2006 – May 2009)AFS ECU Power Source Circuit (from Oct 2006) →