HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
- The intelligent tester can be used at steps 3, 4, 6, and 9.
- The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
| 1.Vehicle Brought to Workshop |
| |||||
| 2.Customer Problem Analysis |
| |||||
| 3.Connect the intelligent tester to DLC3 |
| |||||
| 4.Check and Clear DTCs and Freeze Frame Data |
- HINT:
- (Click here).
| |||||
| 5.Visual Inspection |
| |||||
| 6.Setting the Check Mode Diagnosis |
- HINT:
- (Click here).
| |||||
| 7.Problem Symptom Confirmation |
- HINT:
- (Click here).
|
||||
|
| 8.Symptom Simulation |
- HINT:
- (Click here).
| |||||
| 9.DTC Check |
- HINT:
- (Click here).
|
||||
|
| 10.Basic Inspection |
- HINT:
- (Click here, Click here and Click here).
|
|||||
| |||||
| 11.Mechanical System Test |
- HINT:
- (Click here).
|
|||||
| |||||
| 12.Hydraulic Test |
- HINT:
- (Click here).
|
|||||
| |||||
| 13.Manual Shifting Test |
- HINT:
- (Click here).
|
|||||
| |||||
| 14.Problem Symptoms Table Chapter 1 |
- HINT:
- (Click here).
|
|||||
| |||||
| 15.Problem Symptoms Table Chapter 2 |
- HINT:
- (Click here).
| |||||
| 16.Part Inspection |
|
| 17.DTC Chart |
- HINT:
- (Click here).
| |||||
| 18.Circuit Inspection |
| |||||
| 19.Repair or Replace |
| |||||
| 20.Confirmation Test |
| |||||