2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Skid Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Skid Control ECU Communication Stop Mode
  1. "ABS/VSC/TRC" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Skid Control ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the skid control ECU
  2. Skid control ECU branch wire or connector
  3. Skid control ECU

WIRING DIAGRAM

C126207E13

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. C144958E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-26 (CANH) - A25-15 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE SKID CONTROL ECU BRANCH WIRE OR CONNECTOR (CAN-H, CAN-L)
OK


2. CHECK WIRE HARNESS (POWER SOURCE CIRCUIT)

  1. C144958E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-4 (GND1) - Body ground
    Always
    Below 1 Ω
    A25-1 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A25-18 (IG1) - Body ground
    Ignition switch on
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR


← FAIL-SAFE CHART (Jun 2006 – Sep 2006)Air Conditioning Amplifier Communication Stop Mode (Jun 2006 – Sep 2006) →