SRS Warning Light does not Come ON
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
Click here.WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
| 1. CHECK BATTERY |
Measure the voltage of the battery.
- Standard voltage:
- 11 to 14 V
|
|
||||
| OK | |
| 2. CHECK CONNECTOR |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connector is properly connected to the combination meter assembly.
- OK:
- The connectors is properly connected.
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND) |
Turn the ignition switch to the LOCK position.

Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect the F1 connector from the combination meter assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
F1-1 (B) - Body ground
Always
10 to 14 V
F1-13 (IG+) - Body ground
Ignition switch ON
10 to 14 V
Turn the ignition switch to the LOCK position.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
F1-12 (E2) - Body ground
Always
Below 1 Ω
F1-24 (ES) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK SRS WARNING LIGHT |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Check the SRS warning light condition.
- OK:
- After the primary check period, the SRS warning light goes off for approximately 10 seconds, and then remains on.
- HINT:
- The primary check period is approximately 6 seconds after the ignition switch is turned ON.
|
|
||||
| OK | ||
| ||
