SRS Warning Light does not Come ON
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
Click here.WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
| 1. CHECK BATTERY |
 |
Measure the voltage of the battery.
- Standard voltage:
- 11 to 14 V
|
NG |
 |
|
| CHECK AND REPLACE BATTERY OR CHARGING SYSTEM |
|
|
| OK |
|
 |
|
| 2. CHECK CONNECTOR |
 |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connector is properly connected to the combination meter assembly.
- OK:
- The connectors is properly connected.
|
NG |
 |
|
| CONNECT CONNECTOR PROPERLY |
|
|
| OK |
|
 |
|
| 3. CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND) |
 |
- Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect the F1 connector from the combination meter assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
F1-1 (B) - Body ground
|
Always
|
10 to 14 V
|
F1-13 (IG+) - Body ground
|
Ignition switch on (IG)
|
10 to 14 V
|
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
F1-12 (E2) - Body ground
|
Always
|
Below 1 Ω
|
F1-24 (ES) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE WIRE HARNESS |
|
|
| OK |
|
 |
|
| 4. CHECK SRS WARNING LIGHT |
 |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on (IG).
Check the SRS warning light condition.
- OK:
- After the primary check period, the SRS warning light goes off for approximately 10 seconds, and then remains on.
- HINT:
- The primary check period is approximately 6 seconds after the ignition switch is turned on (IG).
- Result:
Result
|
Proceed to
|
NG
|
A
|
OK (for 2GR-FE RHD)
|
B
|
OK (except 2GR-FE RHD)
|
C
|
|
B |
 |
|
| REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
|
|
|
|
C |
 |
|
| REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
|
|
|
| A |
|
 |
|
|