DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinks of the SRS warning light.
HINT:
When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an ECM malfunction.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
Check if a CAN communication system DTC is output (Click herefor LHD, Click here for RHD).
Result:
Condition
Proceed to
DTC is not output
A
DTC is output
B
B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A
2. CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM)
Turn the ignition switch to the LOCK position.
Disconnect the connector from the ECM.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
E10-13 (TC) - A24-27 (TC)
Always
Below 1 Ω
NG
REPAIR OR REPLACE WIRE HARNESS (TC OF DLC3 - TC OF ECM)
OK
3. CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
E10-4 (CG) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK
4. CHECK WIRE HARNESS (TC OF ECM - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
A24-27 (TC) - Body ground
Always
1 MΩ or higher
NG
REPAIR OR REPLACE WIRE HARNESS OR EACH ECU
OK
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)