2006-2011 Camry Aurion · Service Manual BRAKE

U0073/94 Control Module Communication Bus OFF

Diagnostic trouble codes · Vehicles built from Jun 2009

Also covers:

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The skid control ECU receives the signals from the ECM, steering angle sensor, and yaw rate and acceleration sensor via the CAN communication system.
DTC No.
DTC Detection Condition
Trouble Area
U0073/94
When either of the following is detected:
  1. Bus OFF state continues for 300 msec.
  2. The ECU detects that it cannot send a signal.
CAN communication system
U0100/65
When either of the following is detected:
  1. At a vehicle speed of 6 km/h (4 mph) or more, the skid control ECU receives data that is out of range from the engine.
  2. At a vehicle speed of 6 km/h (4 mph) or more, the skid control ECU receives abnormal data from the engine (5 cycles).
CAN communication system
(Skid control ECU to ECM)
U0123/62
When any of the following is detected:
  1. The skid control ECU receives an abnormal signal from the yaw rate sensor (5 cycles).
  2. The skid control ECU receives a signal that has a shorter message than normal.
  3. The skid control ECU cannot receive a signal from the yaw rate sensor.
CAN communication system
(Skid control ECU to yaw rate and acceleration sensor)
U0126/63
When any of the following is detected:
  1. The skid control ECU receives an abnormal signal from the steering angle sensor (5 cycles).
  2. The skid control ECU receives a signal that has a shorter message than normal.
  3. The skid control ECU cannot receive a signal from the steering angle sensor.
CAN communication system
(Skid control ECU to steering angle sensor)

WIRING DIAGRAM

C145730E06
C145730E07

INSPECTION PROCEDURE

  1. Proceed to CAN communication system troubleshooting (w/ Smart Entry and Start System) (Click here for LHD, Click here for RHD).
  2. Proceed to CAN communication system troubleshooting (w/o Smart Entry and Start System) (Click here for LHD, Click here for RHD).

HINT:
When a DTC indicating a CAN communication system malfunction is output, repair the CAN communication system before repairing each corresponding sensor.


← U0073/94 Control Module Communication Bus OFF (+ U0100/65, U0123/62, U0126/63) (Oct 2006 – May 2009)ABS Warning Light Remains ON (Jun 2006 – Sep 2006) →