Install the park/neutral position switch to the manual valve shaft.
Temporarily install the 2 bolts.
Place a new lock plate and tighten the nut.
Torque:
6.9 N*m{
70 kgf*cm
, 61 in.*lbf
}
Temporarily install the control shaft lever.
Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
Remove the control shaft lever.
Align the groove with the neutral basic line.
Hold the switch in position and tighten the 2 bolts.
Torque:
5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}
Using a screwdriver, stake the nut with the lock plate.
Install the control shaft lever, washer and nut.
Torque:
13 N*m{
130 kgf*cm
, 9 ft.*lbf
}
Connect the park/neutral position switch connector.
2.
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the transmission control cable to the bracket with a new clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Torque:
15 N*m{
148 kgf*cm
, 11 ft.*lbf
}
3.
INSTALL BATTERY
Install the battery and battery tray.
Install the battery clamp with the bolt and nut.
Torque:
Bolt:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
Nut:
3.5 N*m{
36 kgf*cm
, 31 in.*lbf
}
4.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
6.9 N*m{
70 kgf*cm
, 61 in.*lbf
}
5.
INSPECT SHIFT LEVER POSITION
When shifting from the P to the R position with the ignition switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.
Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position. If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
6.
ADJUST SHIFT LEVER POSITION
Move the shift lever to the N position.
Remove the nut from the control shaft lever.
Disconnect the transmission control cable assembly from the control shaft lever.
Push the control shaft lever fully downward.
Return the control shaft lever 2 notches to the N position.
Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.
NOTICE:
Do not damage the boot.
Install the transmission control cable to the control shaft lever with the nut.
Torque:
15 N*m{
148 kgf*cm
, 11 ft.*lbf
}
NOTICE:
If the control cable end is excessively pushed up, the shift lever cannot be adjusted.
When tightening the nut, confirm that the control cable is properly stretched.
Push in the lock piece.
NOTICE:
Firmly push in the lock piece until the slider lock is engaged.
HINT:
After pushing the lock piece make sure that the boot is not deformed.
Start the engine and make sure that the vehicle moves forward when moving the shift lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.