Install the rear No. 2 suspension arm (inside) with the bolt, and temporarily tighten the bolt.
HINT:
Ensure that the paint marks face to the rear of the vehicle.
2.
INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY (w/ Sport Suspension)
Raise the rear suspension member sub-assembly with a jack.
Install the rear suspension member sub-assembly with the 4 differential support member cushions.
Install the 2 rear suspension member lower stoppers and 2 bolts.
Torque:
56 N*m{
571 kgf*cm
, 41 ft.*lbf
}
3.
INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
Raise the rear suspension member sub-assembly with a jack.
Install the rear suspension member sub-assembly with the 2 rear suspension member lower stoppers and 2 bolts.
Torque:
56 N*m{
571 kgf*cm
, 41 ft.*lbf
}
4.
INSTALL REAR SUSPENSION MEMBER LOWER STOPPER LH
Install the rear suspension member lower stopper LH with the 2 nuts.
Torque:
Nut A:
55 N*m{
561 kgf*cm
, 41 ft.*lbf
}
Nut B:
38 N*m{
388 kgf*cm
, 28 ft.*lbf
}
5.
INSTALL REAR SUSPENSION MEMBER LOWER STOPPER RH
Install the rear suspension member lower stopper RH with the 2 nuts.
Torque:
Nut A:
55 N*m{
561 kgf*cm
, 41 ft.*lbf
}
Nut B:
38 N*m{
388 kgf*cm
, 28 ft.*lbf
}
6.
TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM LH
Connect the rear No. 1 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt and nut.
NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.
HINT:
Insert the bolt from the front of the vehicle and temporarily install the bolt.
7.
TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM RH
HINT:
Perform the same procedures as for the LH side.
8.
TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM LH
Connect the rear No. 2 suspension arm (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.
NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.
HINT:
Insert the bolt from the rear of the vehicle and temporarily install the bolt.
9.
TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM RH
HINT:
Perform the same procedures as for the LH side.
10.
TEMPORARILY TIGHTEN REAR STRUT ROD LH
Connect the rear strut rod assembly LH (rear side) to the axle carrier with the bolt and nut, and temporarily tighten the bolt.
NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.
HINT:
Insert the bolt from the inside of the vehicle and temporarily install the bolt.
11.
TEMPORARILY TIGHTEN REAR STRUT ROD RH
HINT:
Perform the same procedures as for the LH side.
12.
STABILIZE SUSPENSION
Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm (inner side) is horizontally aligned with the center of the rear axle hub.