B2412 Headlight Swivel Motor LH Malfunction
Diagnostic trouble codes · Vehicles built from Oct 2006
Also covers:
- B2413 Headlight Swivel Motor RH Malfunction
DESCRIPTION
The swivel motor receives the signal from the AFS ECU to operate and sends the signal indicating the direction of the headlight and condition of the headlight swivel motor to the AFS ECU.| DTC No. |
DTC Detecting Condition |
Trouble Area |
| B2412 |
|
|
| B2413 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select the items below in the ACTIVE TEST and then check that the motor operates.
AFS ECU: Tester Display
Test Part
Control Range
Diagnostic Note
Drive Swivel Motor RH
Swivel motor
RIGHT/OFF
-
Drive Swivel Motor LH
Swivel motor
LEFT/OFF
-
- OK:
- Swivel motor operates normally.
|
|
||||
| NG | |
| 2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
- HINT:
- (Click here)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (AFS ECU - HEADLIGHT ASSEMBLY) |
Disconnect the A61 AFS ECU connector.


Disconnect the A65 or A66 headlight assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
- LH Side (B2412):
Tester Connection
Condition
Specified Condition
A61-1 (SMBL) - A65-3 (SMBL)
Always
Below 1 Ω
A61-23 (SMGL) - A65-4 (SMGL)
Always
Below 1 Ω
A61-29 (SML) - A65-5 (SML)
Always
Below 1 Ω
A61-1 (SMBL) - Body ground
Always
10 kΩ or higher
A61-23 (SMGL) - Body ground
Always
10 kΩ or higher
A61-29 (SML) - Body ground
Always
10 kΩ or higher
- RH Side (B2413):
Tester Connection
Condition
Specified Condition
A61-2 (SMBR) - A66-3 (SMBR)
Always
Below 1 Ω
A61-10 (SMR) - A66-5 (SMR)
Always
Below 1 Ω
A61-24 (SMGR) - A66-4 (SMGR)
Always
Below 1 Ω
A61-2 (SMBR) - Body ground
Always
10 kΩ or higher
A61-10 (SMR) - Body ground
Always
10 kΩ or higher
A61-24 (SMGR) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT AFS ECU |
Reconnect the A61 AFS ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
- LH Side (B2412):
Tester Connection
Condition
Specified Condition
A61-1 (SMBL) - A61-23 (SMGL)
Ignition switch off
Below 1 V
Ignition switch on (IG)
10 to 14 V
- RH Side (B2413):
Tester Connection
Condition
Specified Condition
A61-2 (SMBR) - A61-24 (SMGR)
Ignition switch off
Below 1 V
Ignition switch on (IG)
10 to 14 V
|
|
||||
| OK | |
| 5. REPLACE HEADLIGHT ASSEMBLY (HEADLIGHT SWIVEL MOTOR) |
- OK:
- Returns to normal operation.
|
|
||||
| OK | ||
| ||
