B2414 Steering Position Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The AFS ECU receives the signals indicating the swerve-angle from the steering angle sensor using CAN communication.| DTC No. |
DTC Detecting Condition |
Trouble Area |
| B2414 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select the item below in the DATA LIST and read the display on the intelligent tester.
AFS ECU: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Steer Sens Sig
Steering angle sensor signal value / -382.5° to 382.5°
Approx. 0° (When steering wheel is straight)
-
- OK:
- Normal condition listed above is displayed.
|
|
||||
| NG | |
| 2. CHECK DTC (CAN COMMUNICATION SYSTEM) |
- OK:
- Normal system code is output.
|
|
||||
| OK | |
| 3. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM) |
- HINT:
- (Click here)
- OK:
- Normal system code is output.
|
|
||||
| OK | |
| 4. REPLACE STEERING ANGLE SENSOR |
- OK:
- Returns to normal operation.
|
|
||||
| OK | ||
| ||
