2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Door LOCK Position Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

DESCRIPTION

The main body ECU receives door lock position switch signal to control the illuminated entry system.

WIRING DIAGRAM

E121541E13
E133240E26

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the intelligent tester main switch on.

  1. Select the items below in the DATA LIST, and read the display on the intelligent tester.

    Main Body (Main Body ECU): (without Smart Entry and Start System) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D-Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P-Door Lock Pos SW
    Passenger side or rear RH or rear LH door lock position switch signal / ON or OFF
    ON: Passenger side door or rear LH door or rear RH door is unlocked
    OFF: Passenger side door and rear LH door and rear RH door doors are locked
    -
    Main Body (Main Body ECU): (with Smart Entry and Start System) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D-Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P-Door Lock Pos SW
    Passenger side door lock position switch signal / ON or OFF
    ON: Passenger side door is unlocked
    OFF: Passenger side door is locked
    -
    RR-Door Lock Pos SW
    Rear right door lock position switch signal / ON or OFF
    ON: Rear right door is unlocked
    OFF: Rear right door is locked
    -
    RL-Door Lock Pos SW
    Rear left door lock position switch signal / ON or OFF
    ON: Rear left door is unlocked
    OFF: Rear left door is locked
    -

    OK:
    Normal conditions listed above are displayed.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Door LOCK Position Circuit (Jun 2006 – May 2009)Interior Light Circuit (Jun 2006 – May 2009) →