2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Speaker Circuit

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

When the vehicle has a built-in type amplifier, a sound signal is sent from the navigation receiver assembly to the speakers via this circuit.

WIRING DIAGRAM

E121225E12

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR

  1. E137750E01
    Disconnect the connectors shown in the illustration from the navigation receiver assembly and speakers.

  1. Measure the resistance between each of the front No. 2 speakers and the navigation receiver assembly to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between each of the front No. 2 speakers and each of the front No. 1 speakers to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between each of the rear speakers and the navigation receiver assembly to check for an open circuit in the wire harness.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between each speaker and body ground to check for a short circuit in the wire harness.

    Standard resistance:
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT FRONT NO. 1 SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 4 Ω



NG
REPLACE FRONT NO. 1 SPEAKER
OK


3. INSPECT FRONT NO. 2 SPEAKER
  1. Check that the malfunction disappears when another speaker in good condition is installed.

    Standard:
    Malfunction disappears.

    HINT:
    1. Connect all the connectors to the front No. 2 speaker.
    2. When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
    3. Perform the above inspection on both LH and RH sides.



OK
REPLACE FRONT NO. 2 SPEAKER
NG


4. INSPECT REAR SPEAKER
  1. Resistance check.

    1. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 4 Ω



NG
REPLACE REAR SPEAKER
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Parking Brake Switch Circuit (from Jun 2009)Speaker Circuit (Oct 2006 – May 2009) →