2006-2011 Camry Aurion · Service Manual RESTRAINTS

Driver Side Seat Belt Warning Light does not Operate

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

DESCRIPTION

When the ignition switch ON, the center airbag sensor assembly transmits front seat inner belt state signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver seat belt warning light. If the seat belt is fastened, the warning light goes off.

NOTICE:
The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.


WIRING DIAGRAM

B137085E05

INSPECTION PROCEDURE


1. CHECK FOR DTCs
  1. Check for DTCs.


Result:
Result
Proceed to
Output DTC (CAN communication)
A
Output DTC (Airbag system)
B
No output DTC
C



A
GO TO CAN COMMUNICATION SYSTEM

B
GO TO AIRBAG SYSTEM
C


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".


METER:
Item
Test Details
Diagnostic Note
D-BELT REMIND
D-SEAT BELT indicator light (OFF/ON)
Confirm that the vehicle is stopped with the engine idling

OK:
Switch condition (ON/OFF) can be switched by "ACTIVE TEST".



NG
REPLACE COMBINATION METER ASSEMBLY
OK

END


← ON-VEHICLE INSPECTION (from Jun 2009)Driver Side Seat Belt Warning Light does not Operate (from Oct 2006) →