Driver Side Seat Belt Warning Light does not Operate
Circuit diagnosis · Vehicles built from Oct 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
DESCRIPTION
When the ignition switch on (IG), the center airbag sensor assembly transmits front seat inner belt state signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver seat belt warning light. If the seat belt is fastened, the warning light goes off.- NOTICE:
- The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTCs |
Check for DTCs.
- Result:
Result
Proceed to
Output DTC (CAN communication)
A
Output DTC (Airbag system)
B
No output DTC
C
|
|
||||
|
|
||||
| C | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".
- METER:
Item
Test Details
Diagnostic Note
D-BELT REMIND
D-SEAT BELT indicator light (OFF/ON)
Confirm that the vehicle is stopped with the engine idling
- OK:
- Switch condition (ON/OFF) can be switched by "ACTIVE TEST".
|
|
||||
| OK | ||
| ||
