Front Passenger Side Seat Belt Warning Light Malfunction
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
only G.C.C. countries:When the passenger seat belt is not fastened with the ignition switch in the ON position and the passenger seat occupied, check that the passenger seat belt warning light on the clock display blinks. The occupant detection sensor detects if the passenger seat is occupied and sends signals to the meter assembly. The inner belt detects the passenger seat belt condition and sends signals to the meter assembly. After receiving the signals from the occupant detection sensor and inner belt, the meter assembly sends signals to the clock assembly to request the passenger seat belt warning light to blink or go off.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (BATTERY POSITIVE AND BODY GROUND) |
Disconnect the clock assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
F3-3 (IG) - Body ground
Ignition switch ON
10 to 14 V
|
|
||||
| OK | |
| 2. CHECK CLOCK ASSEMBLY |
Disconnect the clock assembly connector.

Apply battery voltage to the connector according to the table below.
- Standard:
Condition
Specified Condition
Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 10 (PBEW), 19 (GND1)
Comes on (Seat belt warning light)
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (CLOCK ASSEMBLY - COMBINATION METER ASSEMBLY) |
Disconnect the combination meter assembly and clock assembly connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
F1-16 (P/SB) - F3-10 (PBEW)
Always
Below 1 Ω
F1-16 (P/SB) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION COVER) |
Disconnect the occupant detection sensor connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A-1 - A-3
The passenger seat is occupied
Below 100 Ω
A-1 - A-3
The passenger seat is not occupied
Below 1 MΩ
|
|
||||
| OK | |
| 5. CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - FRONT SEAT INNER BELT ASSEMBLY) |
Disconnect the combination meter assembly and front seat inner belt assembly connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
F1-19 (PBKL) - O22-1
Always
Below 1 Ω
F1-19 (PBKL) - Body ground
Always
10 kΩ or higher
O22-3 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 6. REPLACE FRONT SEAT INNER BELT ASSEMBLY (FRONT PASSENGER SIDE) |
Replace the front seat inner belt assembly (front passenger side)
- OK:
- Seat belt warning operation returns to normal.
|
|
||||
| OK | ||
| ||
