C0226/21 SFR Solenoid Circuit
Diagnostic trouble codes · Vehicles built from Jun 2009
Also covers:
- C0236/22 SFL Solenoid Circuit
- C0246/23 SRR Solenoid Circuit
- C0256/24 SRL Solenoid Circuit
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
These solenoids turn on when signals are received from the ECU and they control the pressure acting on the wheel cylinders thus controlling braking force.| DTC No. |
DTC Detecting Condition |
Trouble Area |
| C0226/21 C0236/22 C0246/23 C0256/24 |
Solenoid valve signal does not match the check result. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. RECONFIRM DTC |
- HINT:
- These codes are detected when a problem is identified in the brake actuator assembly.
- The solenoid circuit is in the brake actuator assembly.
- Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
- Result:
Condition
Proceed to
DTC is not output
A
DTC is output
B
- HINT:
- If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the brake actuator assembly. Make sure that no DTCs are output.
- If any DTCs are output while jiggling a connector or wire harness of the brake actuator (skid control ECU), inspect and repair the connector or wire harness.
- It is suspected that the DTCs were output due to a bad connection of the connector terminal.
- If the normal system code is output (the trouble code is not output), slightly jiggle the connectors, wire harness, and fuses of the brake actuator assembly. Make sure that no DTCs are output.
|
|
||||
| A | ||
| ||
