B2275 STSW Monitor Malfunction
Diagnostic trouble codes · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This DTC is output when there is an open, short, or any other problem in the engine start request output circuit inside the main body ECU or in the external circuit.- HINT:
- When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2275 |
ST output circuit (engine starting request signal circuit) inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
- HINT:
- After all DTCs are cleared, turn the engine switch on (IG) and depress the brake pedal. After 15 seconds have elapsed, check if the trouble occurs again.
Check for DTCs again.
- OK:
- No DTC is output.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the E9 ECU connector.


Disconnect the A55 ECM connector (LHD).
Disconnect the A24 ECM connector (RHD).
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E9-4 (STSW) - A55-14 (STSW)*1
E9-4 (STSW) - A24-14 (STSW)*2
Always
Below 1 Ω
E9-4 (STSW) - Body ground
Always
10 kΩ or higher
- HINT:
- *1: LHD
- *2: RHD
|
|
||||
| OK | |
| 3. INSPECT MAIN BODY ECU |
Reconnect the connectors.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E9-4 (STSW) - Body ground
Brake pedal depressed, Engine switch hold on (ST)
Output voltage at terminal AM1 or AM2 is -2 V or more.
|
|
||||
| OK | |
| 4. CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning ECU, check that the engine can start. Make sure the brake pedal is depressed and the shift position is P at this time.
Check that the engine switch mode can be changed by pushing the engine switch.
- HINT:
- Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.
- OK:
- Engine can start normally.
- HINT:
- If engine does not start (Click here).
|
|
||||
| OK | ||
| ||
