B2281 "P" Signal Malfunction
Diagnostic trouble codes · Vehicles built from Jun 2009
DESCRIPTION
The ECM and the shift lock control ECU are connected by a cable and the CAN. If the cable information and CAN information are inconsistent, this DTC will be output.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2281 |
Cable information and CAN information between main body ECU (instrument panel junction block assembly) and shift lock control ECU are inconsistent |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- When the main body ECU (instrument panel junction block assembly) is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
| 1. READ VALUE USING INTELLIGENT TESTER |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
Main Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Shift P Sig
Shift P Signal / ON or OFF
ON: Shift P signal ON (Shift position is P)
OFF: Shift P signal OFF (Shift position is not P)
-
- OK:
- "ON" (P signal is ON) and "OFF" (P signal is OFF) appear on the screen.
- HINT:
- If the result is not as specified, there may be a malfunction with the shift lock control ECU (Click here).
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU) |
Disconnect the E9 and E57 connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E9-2 (P) - E57-11 (P2)
Always
Below 1 Ω
E9-2 (P) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) OPERATION |
After replacing the main body ECU (instrument panel junction block assembly) with a normally functioning ECU, check that the engine can start normally. Make sure the brake pedal is depressed and the shift position is P at this time.
Check that the engine switch mode can be changed by pushed the engine switch.
- HINT:
- Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.
- OK:
- Engine can start normally.
- HINT:
- If engine does not start (Click here).
|
|
||||
| OK | ||
| ||
